Installing Your New Appliance - Sibir GSN 20010 Mode D'emploi

Installing your new appliance

Before using the appliance for the first
time, you should review the following
tips.
Ventilation of appliance
In order to improve efficiencyof
the cooling system and save
energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.For
this reason,sufficient clear space should
be available around the refrigerator.
It is advisable for there to be 50-70mm
of space from the back to the wall,at
least 100mm from its top,at least
100mm from its side to the wall and a
clear space in front to allow the doors to
open 135°. Please see the following
diagrams.
Note:
●
This appliance performs well within the
climate class from N to ST showed in
the table below. It may not work properly
if being left at a temperature above or
below the indicated range for a long
period.
Climate class Ambient temperature
SN
N
ST
T
Stand your appliance in a dry place to
●
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
avoid high moisture.
Keep the appliance out of direct
●
sunlight, rain or frost. Stand the
appliance away from heat sources such
as stoves, fires or heaters.
Leveling of appliance
For sufficient leveling and air
●
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted.
You can adjust them manually by
●
hand or by using a suitable spanner.
To allow the doors to self-close, tilt
●
the top backwards by about 10mm.
Door handle installation
Take the handle and screws out of the
bag, remove the handle covers from the
handle, position the handle on the right
side of door, fix it by screws and cover
the handle covers.
8