Ryobi EHG-2002C Manuel D'utilisation page 10

GB
F D
USING THE HEAT GUN
If your heat gun model has variable temperature
control (3) / LCD which you can rotate to adjust to
different temperature. If your heat gun model has LED
temperature indicator (6) (Fig.4) or LCD temperature
indicator (7) (Fig. 5) then you can take a reference on the
LED/LCD indicator to know what is the approximate
working temperature.
STRIPPING PAINT AND VARNISH
The following procedure and techniques make it easier to
strip paint and varnish. Always test a small area of paint
before attempting to strip large areas.
Turn the heat gun on and allow it to warm up to operating
temperature. Position the nozzle 10cm from the paint to
be stripped. Soon, the paint should wrinkle and blisters
start to form. Do not overheat the paint as this may burn
it and make it more difficult to remove. Always wear eye
protection when stripping paint overhead.
Start by warming the surface just in front of the scraper
uniformly by moving the hot air gun slightly from side to side.
If you heat the paint properly, you will be able to strip even
the thickest paint in one pass. The paint should come off in
strips the same width as the scraper.
Clean the scraper blade frequently to keep it clean and
sharp and to prevent a build-up of paint on the scraper.
Remove the paint while it is still soft as it hardens rapidly.
You can strip moulded surfaces with a wire brush after
softening the paint with the hot air.
Protect surfaces that should not be heated using
nonflammable material. Avoid directing the heat from the
heat gun onto windows or other glass surfaces.
NB: The heat gun is designed to strip both oil and water
based paints and varnishes. The heat gun cannot
remove wood stains or primers impregnating the wood.
WARNING
FUMES FROM LEAD-BASED PAINT ARE
HIGHLY TOXIC. ALWAYS PROVIDE ADEQUATE
VENTILATION WHILE WORKING INDOORS.
E I P NL S DK N FIN
English
OTHER USES FOR THE HEAT GUN
Removing paint and varnish using the hot air with a
■
paint scraper. (Fig. 3)
Removing labels and adhesive tape.
■
Loosening rusty or overtightened bolts and screws.
■
Thawing frozen pipes, locks, etc.
■
Raising the grain of wood before varnishing or staining.
■
Drying paints and varnishes quickly. This is particularly
■
useful when the colour is being changed and several
coats of paint or varnish are necessary.
Drying damp and damaged wood before filling
■
and repainting.
Shrinking heat shrink film for packaging.
■
Wax modelling.
■
Heat shrinking.
■
Do not use the heat gun to thaw pipes protected by a
plastic film.
CARE OF YOUR HEAT GUN
Keep the air intake and hot air nozzle clean and free of
dust and debris.
Use only a damp cloth and ordinary household cleaners
for cleaning the heat gun.
Do not use white spirit, thinners, petrol or other similar
chemicals to clean the hot air gun.
NOISE
The sound pressure level in the working area may
exceed 85dBA. The user should, therefore, set up sound
absorbing materials and wear ear protection.
CAUTION-AUTO OFF THERMAL SWITCH
This unit is a thermostatically protected heat gun. If the
unit is operated for a prolonged period of time,
the thermostat may activate and cut off the power to
protect the unit from overheating. If this happens, turn off
the switch immediately and disconnect the unit from the
power supply.
The thermostat will automatically reset after 30 minutes
until the unit cool down and normal use can then be
resumed. Failure to follow this instruction may result in
damage to the machine and personal injury.
7
GR H CZ RUS RO PL