LOTRONIC BST PORT4BT Manuel D'utilisation page 6

PORT4BT / PORT4BT-H
Thank you for having chosen our A BST PA SYSTEM. For your own safety, please read this user manual carefully before installing the device.
SAFETY INTRODUCTION
 If the device has been exposed to temperature changes due to environmental changes, do not switch it on immediately. The arising
condensation could damage the device. Leave the device switched off until it has reached room temperature.
 It is essential that the device is earthed. A qualified person must carry out the electric connection.
 Make sure that the available voltage is not higher than stated at the end of this manual.
 Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to replace the power cord.
 Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord by plug. Never pull out the
plug by tugging the power cord.
 DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
CAUTION:
1. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep away from children and non-
professionals.
2. The light doesn't include any spare parts for repair, please check if all the parts are well installed and screws are fitted tightly before
operating. Do not use the light when the cover is open.
GENERAL GUIDELINES
 This device is only allowed to be operated with an alternating current of max. 100Vac/60Hz – 240Vac/50Hz and was designed for indoor use
only.
 Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not qualified for operating the
device. Most damages are the result of unprofessional operation.
 Please use the original packaging if the device is to be transported.
 For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other operation may lead to short-
circuit, burns, electric shock, crash, etc. If this device will be operated in any way different to the one described in this manual, the product
may suffer damages and the guarantee becomes void.
1) MAIN DESCRIPTION
1) MAIN VOLUME CONTROL
Use to adjust the main volume control of the speaker
2) TONE CONTROL
Use to adjust the tone control of the main signal ( more bass or more treble )
3) LINE OUT
Use to send master signal to another speaker, mixer or power amplifier
4) POWER SWITCH
Use to switch the speaker on or off
5) MIC INPUT
Use to connect a wired microphone ( connectorJack 6.35mm )
6) RF LED
This led lights on when you swith the wireless transmitter on ( Handheld mic or belt transmitter ). If the led stay off, check the frequency or the
batteries of the transmitter
7) POWER / CHARGE LED
This led give you an information about built‐in battery state.
When you connect the speaker to the main power supply, the battery will automaticaly charge
If the led lights green, that means the speaker is on and full charged.
If the led lights orange, that means the speaker is on but the battery is on charge
If the led is red, that means the battery is low. You must to charge it
8) PREVIOUS SONG BUTTON ( MP3 / BLUETOOTH )
Use to select the previous song ( in MP3 USB or Bluetooth mode )
9) PLAY / PAUSE BUTTON ( MP3 / BLUETOOTH )
Use to start the playback or to pause the song ( in MP3 USB or Bluetooth mode )
10) NEXT SONG BUTTON ( MP3 / BLUETOOTH )
Use to select the next song ( in MP3 USB or Bluetooth mode )
11) USB CONNECTOR
Insert your USB key in this connector. Note : Don't use USB key more that 8Go
12) MODE BUTTON
Use to choose operating mode : MP3 USB or Blutooth
In MP3, just insert the USB key
For That, please check the user manual of your Bluetooth device
© Copyright LOTRONIC 2015
ENGLISH
WWW.BSTDJ.COM
Page 6