Maintenance; Daily Maintenance; Weekly Maintenance; Monthly Maintenance - Haussmann Xpert XAC228 Manuel De L'utilisateur

OPERATION
WARNING! Wear safety goggles when opening the petcock. The escaping air
!
can raise debris particles which can damage your eyes.
z After 2 weeks, tighten all nuts and bolts, including head bolts.

MAINTENANCE

WARNING! Before any maintenance or adjustments to your air compressor,
always take the following safety precautions:
!
z Disconnect electrical power.
z Open the petcock to drain air tank of pressure.

DAILY MAINTENANCE

Before each use:
z Check the oil level.
z Be sure all nuts and bolts are tight.
z Check for any unusual noise or vibration.
z After use: open the air tank drain cock to drain condensation from tank. This is
especially critical in cold conditions when condensation could freeze in the tank
and cause mechanical damage as well as rust.

WEEkLY MAINTENANCE

z Clean the air filter by twisting open the metal air filter cap.
z Remove the filter element and clean it thoroughly with soap and water.

MONTHLY MAINTENANCE

z Inspect air system for leaks by applying soapy water to all joints. Tighten those
joints if leakage is observed.
z Check that all nuts and bolts stay tight.
250 HOURS OR 6 MONTHS
OIL CHANGE
z After 250 hours of use, your compressor will require an oil change.
z Paint spraying operations or dusty environments may require you replace oil
more often
WARNING! Before removing the oil drain plug or the oil fill cap from your air
compressor, always take the following safety precautions:
!
z Disconnect electrical power.
z Open the petcock to drain air tank of pressure.
1. Remove the oil drain plug. Allow oil to drain completely.
2. Replace the oil drain plug (we recommend the use of a sealing compound or
tape to avoid leakage). Do not over-tighten.
3. Through the oil fill hole, refill the reservoir with SAE-20 or SAE-30 (API CG/CD
heavy duty), non-detergent compressor oil. For extreme winter conditions, use
SAE-10 weight
4. Fill to the red dot in the oil level sight glass. Do not over-fill.
5. Replace the oil fill plug.
(WHICHEVER COMES FIRST)
27