Operating The Trimmer - GBC AccuCut A515pro 3in1 Manuel D'utilisation

AccuCut
Specifications
Models
Product code
Sheet Capacity 80g/m 2 *
Cutting Length
Integrated Paper Guide
Size Guide
Score
Perforate
* refer to paragraph 4 in the operating the trimmer, section D.
Trimmer base with calibrated grid
Metric and Imperial scale guide
Magnetic Back Stop
Rotary blade / handle assembly
Cutting Edge Guide
Safety cutting mat
Manual clamp
Paper Guide

Operating the Trimmer

Place the trimmer on a stable, flat surface such as a
1
table.
A. Slide the rotary blade housing to the top of the
2
stationary rail. A1. To change cutting style push and
hold the blade selector knob while turning to select the
function desired.
B. Raise the clamping handle and place the sheets (30
3
sheets Max.) to be trimmed at the desired position.
Cutting Restrictions
• Remove staples, paper clips etc. before cutting.
• Do not cut metal film, film containing glass etc.
• Do not cut more sheets than cutting capacity allows.
• Do not carry trimmer by holding on to the cutting
blade handle.
4
A515pro 3in1 / A525pro 3in1 /
A535pro 3in1
A515pro 3in1 A525pro 3in1
AC001230 AC001235
30 30
380mm 457mm
A4, A5, A6 & A7 A3, A4, A5, A6 & A7
Centimetres and Inches Centimetres and Inches
1-5 sheets 1-5 sheets
1-5 sheets 1-5 sheets
A535pro 3in1
AC001240
30
609mm
A3, A4, A5, A6 & A7
Centimetres and Inches
1-5 sheets
1-5 sheets
NOTE: Please retain this information
regarding safe operation of this
paper trimmer
CAUTION: Trimmer should be operated
by an adult or under adult
supervision
CAUTION: Sharp blade, do not touch the
edge of the blade
C. Hold sheets securely in place and lower the
4
clamping handle. D. Push down on the rotary blade
housing and slide to cut. Several cutting passes may be
necessary to completely cut through all sheets
depending on the load inserted.
TIP: In addition to using the grid pattern and scale for
alignment, use the transparent cutting edge guide
to quickly and accurately align your cuts.
• Always operate trimmer with both hands and on a stable
base or desk.
• Check the fittings of the rotary blade and safety cutting
rail from time to time.