Making A Cut; Routine Maintenance - Battipav Super Pro 450 Mode D'emploi

GB

4. Making a cut

CAUTION !
a) Rest the tile on the worktable, with the cutting
point aligned. Position the carriage and set up
the cutting wheel using the side levers as
indicated in photo 8.
8
b) Proceed to cut the glaze by pushing on the
movement rod and exerting a constant
downward pressure for the entire length of the
tile.
c) Position the breaking foot using the side levers
on the carriage (photo 9).
9
d) Then exert a gradually increasing pressure until
the tile is separated (photo 9).
Use the graduated rods and the adjustable square
for repetitive cuts and / or specific cutting angles.
CAUTION !
WHEN WORKING WITH HARD TILES, IT IS
ADVISABLE TO PRESS THE BREAKING FOOT
AGAINST ONE END OF THE TILE UNTIL IT
STARTS TO SEPARATE. COMPLETE THE
BREAK BY PRESSING ON THE OTHER END.

5. Routine maintenance

CAUTION !
a) Remove any encrustation or residue from the
carriage rod, without lubricating it.
b) Adjust the cutting wheel by tightening the 3 mm
male hexagonal-headed screw using the
wrench supplied, to remove any lateral play,
without blocking it (photo 8).
10
c) Remove all vertical play on the carriage by
tightening the screw indicated (photo 11), using
the 2,5 mm Allen wrench provided.
11
d) Remove all lateral play on the carriage by
tightening the screws indicated (photo 12),
using the 2 mm Allen wrench provided.
12
12