Technical Data - Battipav Super Pro 450 Mode D'emploi

GB

Technical Data

Art. 3045 Art. 3060
Cutting length
450 mm 600 mm
Max. tile size
31x31 cm 42x42 cm
Weight
13 Kg 16 Kg
Cutting thickness:
Tool:
TUNGSTEN CARBIDE WHEEL
Tool diameter:
Intended use:
CERAMICS, SINGLE-FIRED TILES, GRES,
KLINKER, TERRACOTTA AND MARBLE.
1. Use
CAUTION !
All our tools undergo a series of tests and are
carefully checked before they leave our factory.
BATTIPAV is constantly involved in developing
the equipment we supply. We therefore reserve
the right to make any changes we deem
necessary. No demands may therefore be made
on the basis of the information and illustrations
found in this manual.
The SUPER PRO tile cutter is a tool that is
technologically advanced and that offers high
performance. It is suitable for cutting ceramic
materials.
2. Warning
• The manufacturer accepts no responsibility for
SUPER PRO tile cutters used with other tools,
or for cutting any materials other than those
indicated in the "INTENDED USE" paragraph.
Art. 3075 Art. 3090
750 mm 900 mm
52x52 cm 63x63 cm
19 Kg 22 Kg
5-19 mm
Art. 492
Ø22x6,1x4,7 mm
3. Assembly
Remove the machine from the packaging and
ensure that no component has been damaged.
Proceed by assembling the SUPER PRO tile cutter
according to the type of use you wish to implement.
RIGHT-HANDED OPERATORS
a) Set up the carriage rod unit onto the worktop, as
shown in picture 1.
1
Block the carriage rod unit into place with the
four screws supplied, ensuring that the cutting
wheel remains in the centre of the cutting side,
along its entire length (picture 2)
2
b) Then tighten the nuts with the 10 mm hexagonal
spanner.
c) Remove the two M6 nuts from the rod onto
which the tile rests, with the 10 mm hexagonal
spanner (Ref. exploded view Pos. 10 - Art. 30092).
3
10