Defrosting; Temperature Alarm / Door Alarm; Door Lock; Shelves - Summit Classic Collection CL67ROSB Mode D'emploi

Réfrigérateurs sans givre pour usage intérieur et extérieur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DEFROSTING

The unit defrosts automatically in normal operating conditions.
The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in the
drainage channel behind the rear wall of the unit, and flows through the drainage hole into the drip
tray by the compressor where it evaporates.
However, frost may accumulate on the evaporator if the unit is repeatedly opened in a high heat or
high humidity location. If this frost pattern does not clear within 24 hours, your unit will require manual
defrosting.

TEMPERATURE ALARM / DOOR ALARM

An audible alarm sounds if the storage temperature is not cold enough. The temperature display
flashes at the same time.
The cause of the temperature being too high may be:
– Warm fresh food was placed inside
– Too much warm ambient air flowed in when rearranging or removing food
– Power failure for some time
– The appliance is faulty
The audible alarm is automatically silenced and the temperature display stops flashing when the
temperature is sufficiently cold again.
If the door has been left open for more than 60 seconds, the alarm will sound. Pressing the POWER
key once can switch off the audible alarm.

DOOR LOCK

Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the Instruction Manual. Insert the key into the
lock and turn it counter-clockwise to unlock the door. To lock the door, do the reverse operation, making
sure the metal pin is engaged completely. Remove the key and put it in a secure place for safekeeping.

SHELVES

To prevent damaging the door gasket, make sure to have the door all the way open when pulling the
shelves out of the rail compartment.
Any of the shelves can be removed to store larger items.
When removing the shelf out of the rail compartment, make
sure to remove all items first. Then move the shelf to the
position where the notch of the shelf is exactly under the
plastic post and lift the shelf. In order to replace the shelf,
repeat steps described above in reverse.
10

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cl69rosw

Table des Matières