Summit Classic Collection CL67ROSB Mode D'emploi page 13

 "E0" indicates a communication error for
3-zone models.
 "E1" or "E2" indicates that the air
Display "E0",
"E1". "E2",
temperature sensor has failed.
 "E3" or "E4"indicates that the defrost
"E3", "E4",
"E5" or "E7".
sensor in the evaporator has failed.
 "E5" indicates a defrost heater failure.
 "E7" indicates a door switch failure.
Has the appliance door been open for
longer than 60 seconds? If not, then the
temperature has risen higher or fallen
lower than the temperature that has been
The alarm
set. This could be due to:
sounds and
 The appliance door being opened too
the
often.
temperature
 The ventilation opening being covered
display
or too dusty.
flashes.
 A lengthy interruption in the power
supply.
 A large amount of items have been
added to the unit.
 The display temperature is out of range.
The icon "--" is
lit and flashing
in the
temperature
display.
If you've checked the table above and find that you still need help with your appliance, call our Customer
800-932-4267
Service facility at
questions.
CALIFORNIA CARB/SNAP DISCLOSURE
January, 1, 2019:
Retail food refrigeration equipment manufactured after January 1, 2019,
designed to store and display chilled goods for commercial sale, and that use
HFC-134a/R134a refrigerant are not for sale in California.
*This product uses eco-friendly hydrocarbon refrigerant and fully complies with
California CARB regulations. However, we are required by California Law to
provide the previous disclosure statement in every product sold in California.
This product does not use any refrigerants on the "List of Prohibited
Substances."
between 9:00AM and 5:00PM ET. We will do our best to answer your
13
 Call for service.
If yes, close the door.
 Do not open the door more often than
necessary.
 Clear the obstructions and clean off
the dust.
 Leave the appliance to work for a
while until the set temperature has
been reached.
 Only temperatures within the range
0~99°F/-9~37°C can be displayed. If
the temperature is not within this
range, the icon "--" will be displayed
instead. This is normal.
For products manufactured after