KS Tools 161.0361 Notice D'utilisation page 9

Cric 2 t
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Locate the jack in a suitable working area.
2. Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition,
leaking hydraulic fluid, or unstable due to loose or missing hardware or parts. Make corrections
before using
3. Use jack on level and solid ground, preferably concrete. Avoid tar macadam as jack may sink in.
Chock wheels of vehicle.
4. Ensure the vehicle handbrake is engaged, engine is switched off and transmissions in gear (or
"PARK" if automatic).
5. Ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc, to
allow for vehicle tilting.
6. Ensure all non-essential persons keep a safe distance whilst the jack is in use.
7. Ensure there no passengers in the vehicle.
8. Place jack under only those lifting points recommended by vehicle manufacturer (see vehicle
handbook)
9. Check that the lifting point is stable and centered on the jack saddle.
10. Ensure the jack wheels are free to move and that there are no obstructions.
Danger : Use the jack for lifting only
11. Ensure there are no persons or obstructions beneath the vehicle before lowering.
12. Use suitable axle stands under the vehicle before proceeding with any task.
13. Use a qualified person to lubricate and maintain the jack.
14. Wear ANSI-approved safety goggles and heavy-duty working gloves during use.
15. Ensure that only hydraulic jack oil is used in the jack.
DO NOT operate the jack if damaged.
DO NOT allow untrained persons to operate the jack.
DO NOT exceed the rated capacity of the jack.
DO NOT allow the vehicle to move during lifting or lowering, or use the jack to move the vehicle.
DO NOT jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
DO NOT work under the vehicle until appropriately rated axle stands have been correctly which it is
Intended.
DO NOT fill hydraulic system with brake fluid, alcohol or transmission oil. Use hydraulic jack oil only.
DO NOT adjust the safety overload valve.
DO NOT use for aircraft purposes.
16. When not in use store jack, fully lowered, in a safe, dry, childproof location.
17. The warnings, precautions, and instructions discussed in this manual cannot cover all possible
conditions and situations that may occur. The operator must understand that common sense and
caution are factors, which cannot be built into this product, but must be supplied by the operator.
Warning!

Publicité

Table des Matières
loading

Table des Matières