Honda Power Products UMC425E Manuel De L'utilisateur page 34

3.Insert the attachment until the set pin knob clicks. Confirm the "
mark on the attachment is at the joint holder end.
SET PIN KNOB
4.Pull the attachment and joint holder to the arrow direction to check
that the attachment will not come loose.
5.Tighten the joint knob.
JOINT KNOB
CAUTION:
When you place the power head with the recoil starter facing down, be
careful not to make impact to the recoil starter. Recoil starter or the
engine might get damaged from the impact.
JOINT HOLDER
4
5
TIGHTEN
JOINT HOLDER
ATTACHMENT
ATTACHMENT
"
31