Technical Specifications; General Specifications - VINCENT STU-400 Manuel D'utilisation

Symptom
The remote control
cannot perform any
functions
Humming low fre-
quency noise is
audible, even as
no audio source
is playing back

General Specifications

Outputs:
AC power connection type:
Dimensions (W x H x D):
Weight:
Colour:
FM Tuner
Frequency range:
Sensitivity:
Frequency Response:
Channel Separation:
Total Harmonic Distortion (1 kHz):
Signal to noise ratio:
Antenna input:
AM Tuner
Frequency range:
Sensitivity:
Total Harmonic Distortion (1 kHz):
Signal to noise ratio:
Antenna input:
Vincent Vincent
38 38
SEARCH FOR ERRORS
Possible Cause
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated
from a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the
chapter "Tips".

TECHNICAL SPECIFICATIONS

Countermeasure
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear, wit-
hin a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
See section "Net frequency noise" in the
chapter "Tips".
1x stereo RCA analog
230 V / 50 Hz AC
430 x 98 x 345 mm
5.5 kg
black/silver
87 MHz – 108 MHz (50 kHz steps)
12 dBµ mono
40 Hz - 12 kHz, +1 dB/-1,5 dB
> 30 dB (1 kHz)
mono: 0,8%, stereo: 0,9%
mono: 62 dB, stereo: 60 dB
75 Ω
522 kHz -1611 kHz (steps of 9 kHz)
55 dBµ/m
2% at 30% mod.
38 dB at 30% mod.
Frame antenna or outdoor antenna