Care And Storage - Novus 07676 Mode D'emploi

EN
3. Completely unwind the mains cable (8) and plug the mains plug into an easily acces-
sible plug socket (100 – 240 V ~ 50/60 Hz).
4. Switch on the device. To do this, press the
5. Select the temperature setting: After the device is switched on, it automatically heats
up to 160°C. To increase the temperature, keep pressing the
LED (10) of the temperature setting you want fl ashes. NOTE: After the highest tem-
perature setting, the device then switches off.
6. Heat up the device. As it is heating up, the corresponding LED (10) fl ashes. When the
set temperature level has been reached, it is lit up permanently.
The device has a button lock to prevent accidental adjustment of the temper-
ature setting. When the LED (10) of the set temperature level is lit up perma-
nently, press down the
lights up. To cancel the button lock again, press down the
the display of the button lock (9) goes out.
7. Divide the hair up into sections and use the styling brush to style it as follows:
For smoothness and volume:
Place one strand in each case at the hairline over the front side of the brush head (11)
and pull them up to the tips. Curl the brush head (11) out on the ends. Repeat this
until you get a satisfactory result.
For waves:
Wrap each strand around the entire brush head (11) two to three times, wait a little
while, then carefully unwind them again. Depending on the thickness of the hair, keep
the strand wound around the brush head (11) for an appropriately long period of time.
8. Switch off the device after styling and pull the mains plug out of the plug socket. To
switch it off, keep pressing the

Care and Storage

CAUTION!
■ Danger of electric shock! Remove the mains plug from the plug socket before
cleaning the device. Keep the device, the mains cable and the mains plug away from
water or other liquids.
■ The brush head is still hot after it has been switched off. Allow it to cool down com-
pletely prior to cleaning and storage. Only place it down on heat-resistant surfaces.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
1. Pull the mains plug out of the plug socket and allow the device to cool down com-
pletely.
2. Remove hair, fl uff or dust from the brush head (11).
3. If necessary, wipe down the device with a slightly damp cloth, and then dry it. With
more intense soiling, a mild cleaning agent can be used.
4. Keep the device out of the reach of children and animals in a dry, frost-free place that
is protected from direct sunlight.
16
button (5).
button (5) until the
button (5) until no more LED (10) is lit up.
button (5) until the
display of the button lock (9)
button (5) until