ADE MZ10023-1 Manuel D'utilisation page 7

Assembly to ADE column scale:
Place the assembling block for fixing the height rod at the backside of the column over the
two holes at the column of the scale. Use the 2 x M5 screws and turn them carefully tight.
Place the height rod with the printed side onto the assembling block by using the two
mounting holes and fix the rod by using the M6 screw (lower hole). Make sure that the screw
is tightened well.
Assembling to the wall:
Carefully measure with an exact measure 56 cm from the floor and mark
the wall. Pull out the height rod to full length. Exactly place the height
measure over the marking at the hole beneath the 60 cm point on the
height measure. Use a spirit
level to align the height rod and mark the wall at the second fix point at
122,5 cm.
Drill holes right at the marking and use the supplied dowels.
You will need 1 washer for the lower screw. Slide the washer over the
screw and insert the screw through the lower hole of the measuring rod
from the printed side. Do the same with the second screw using the upper
hole. Now place the two spacers over the screws. Place the two screws
into the dowels. Make sure both screws have been carefully tightened.
Safety advice
Follow the instructions of the Operating Manual.
Attach the height rod only on ADE column scales. After finishing the
measurement make sure to fold the measuring tongue down to avoid danger of injury.
Operating Instructions
1. Adjust the measuring tongue to a horizontal position.
2. Slide the measuring tongue up just above of the person to be measured.
3. Place the person to be measured under the measuring tongue.
4. Slide the measuring tongue down to the person's head.
5. Take the result from the readout point.
Please read the length at the red line.
To measure below 134 cm, please press the button at centre of the measuring
tongue and slide the measuring tongue down.
6
Installation
MZ10023-210420-Rev006-UM-de-e-fr-nl