Overload Protective Device For Poly-V-Belt - Hitachi C 12FSA Mode D'emploi Et Instructions De Securite

1. Mounting the saw blade (Fig. 41-a, Fig. 41-b and Fig. 41-c)
(1) Press in spindle lock and loosen bolt with 17mm box wrench.
Since the bolt is left-hand threaded, loosen by turning it to the right as shown in Fig. 41-b.
NOTE:
If the spindle lock cannot be easily pressed in to lock the spindle, turn the bolt with 17mm
box wrench while applying pressure on the spindle lock.
The saw blade spindle is locked when the spindle lock is pressed inward.
(2) Remove the bolt and outside washer (B) and collar (B) as shown in Fig. 41-c.
The collar (B) have outside diameter of 1" (25.4mm) as shown in Fig. 41-c.
17mm Spindle Lock
Box Wrench
Fig. 41-a
(3) Lift the safety cover and mount the saw blade.
WARNING:
When mounting the saw blade, confirm that the rotation indicator mark on the saw
blade and the rotation direction of the side cover (L) (see Fig. 1) are properly matched.
(4) Thoroughly clean washer (B) collar (B) and the bolt, and install them onto the saw blade spindle.
(5) Press in the spindle lock and tighten the bolt by turning it to the left by standard accessorie's wrench
(17mm box wrench) as indicated in Fig. 41-b.
CAUTION:
* A dust guide is installed inside behind the side cover (L).
When removing or installing the saw blade, do not make contact with the dust
guide. Contact may break or chip saw blade tips.
* Confirm that the spindle lock has returned to the retract position after installing or
removing the saw blade.
* Tighten the bolt so it does not come loose during operation.
Confirm the bolt has been properly tightened before the power tool is started.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.
CAUTION:
Never attempt to install saw blades larger than 12" (305mm) in diameter.
Always install saw blades that are 12" (305mm) in diameter or less.

OVERLOAD PROTECTIVE DEVICE FOR POLY-V-BELT

The power of the motor is transmitted to the saw blade by a Poly-V-Belt. When the Poly-V-Belt becomes
overloaded, the overload protective device cuts off the current to stop the motor.
In this case turn the switch off immediately and raise the handle to its initial position. Then turn the switch
on and after running the tool for 20 seconds without a load for cooling of the motor. Then start the cutting
operation. The Poly-V-Belt or the motor will be damaged if the overload protective device turns off frequently.
CAUTION:
When the overload protective device stops the motor, the motor will start by turning the
switch on after turning it off. When turning the switch on, make sure that the saw blade
is not halfway in the material.
All manuals and user guides at all-guides.com
Tighten
Dust Guide
Fig. 41-b
Bolt
Washer (B)
Washer
(B) Collar
(B)
Loosen
English
Saw Blade
Washer
17mm Box
(B)
Bolt Wrench
Fig. 41-c
23