Publicité
Les langues disponibles
Les langues disponibles
EN
Assembly instructions
1. Take a look at the sketch first, then screw together both of the side boards which
then will function as crossed legs of the framework. After that, organize all the
other boards so that all of the sideways drillings lay above center. Make sure that
the ends of the framework are always flat on the floor. It might be necessary to
rotate the legs a little.
You can adjust the height with the help of the pre-drilled holes in the framework.
If you choose holes in the center of the legs, the height is approximately 70cm.
2. Connect both of the now crossed legs with the help of the connection bar (take a
look at the sketch again). After that, attach the bottom boards to the legs as
stabilization for the lower framework.
3. Screw the table top with tools fixture to the front, narrower standing feet.
4. Put the countertop on top of the framework.
5. Mount it (from above) on the connection bar of the lower framework with the help
of 2 coach bolts.
6. The top of the not connected legs have to be screwed to the border of the
countertop.
7. Finally attach the clamping bar to the front of the countertop.
8. Always remember that wood is a living material and therefore 'works' during wet
conditions.
9. It might be necessary to slightly change the pre-drilled holes.
10. Both of the wooden corks fit in the pre-drilled holes on the countertop and function
as fixation tool.
CAUTION!
• To be used under the direct supervision of an adult.
• Screws have to be checked regularly.
• While folding workbench do not grasp into shear area of the legs.
• Do not sit on top of the countertop.
• These assembly instructions have to be kept accurately.
Publicité
