Explore Scientific RGT1001 Mode D'emploi page 8

Spanish (S).
RAINFALL SETTING
1. The device will register RF signal for 4 minutes
automatically when power on.
2. In standard mode, press and hold [ DOWN ] for 2 seconds
to manually receive the value.
Current rainfall value: 0 mm ~ 99.96 in (0 ~ 2539mm)
Total rainfall value: 0 mm ~ 999.96 in (0 ~ 25399mm)
Rainfall unit: mm or inch
3.Press [ IN/MM ] button to select the rainfall unit in mm or
inch.
4. The rainfall default displays the amount of daily rainfall.
You can press [ UP ] to check the past 9 days rainfall. And
press and hold the [ SINCE ] to clear the value.
RAIN ALERT
SETTING/ADJUSTING RAINFALL ALARM
1. Press and hold [ RAIN ALERT ] button, enter rainfall alarm
setting.
2. Press [ UP ] button once to increase by 1 or press
8
[ DOWN ] once to decrease by 1. Alternatively, press and
hold the button to change the figures rapidly.
3. Press [ RAIN ALERT ] button to confirm setting.
NOTE:
When today's rainfall value is more than the alarm value,
the alarm will bleep for 60 seconds, press any button to
stop the alarm.
TURN ON/OFF RAINFALL ALARM
1. In standard mode, press the [ RAIN ALERT ] button once to
turn on/off the rainfall alarm.
2. When display the rainfall alarm value, do not press any but-
ton. The alarm will be turned on after 6 seconds.
3. When display"----", do not press any button. The alarm will
be turned off after 6 seconds.
SPECIFICATIONS
MAIN UNIT:
Dimensions:
94x50x172mm (L x W x H)