Insert Batteries; Set The Clock Manually - Explore Scientific RGT1001 Mode D'emploi

INSERT BATTERIES

1. Remove the mounting ring at the bottom of the rain
sensor and unscrew the watertight battery door.
2.Remove the battery compartment cover of the main unit.
3. Insert 3x AA and 2xAA (LR03)/1.5V batteries into main
unit and rain sensor respectively. Please ensure the
polarities (+/-) of the batteries match upon installation.
4. Reattach the battery covers and mounting ring.
NOTE:
- Ensure the watertight O-ring is properly aligned in place to
ensure water-resistant.
- Replace batteries when [
display is dim.
RAIN SENSOR INSTALLATION
The base station and rain gauge should be positioned
within an effective range: about 100 meters (328 feet) in an
open area. The rain gauge should be mounted horizontally
in an open area away from trees or other obstructions to
allow rain to fall naturally for an accurate reading. You may
insert the three mounting screws (included) through the
holes in the base of the rain sensor.
] displays, or when the
CLOCK
In standard mode, press [ MODE ] button to check the time,
week and calendar.

SET THE CLOCK MANUALLY

1. Press and hold [ MODE ] button to enter time and date
setting.
2. The setting parameter will flash.
3. Press [ UP ] button once, the figure will increase 1 unit.
Press and hold the [ UP ] button, the figures will increase
rapidly.
4. Press [ DOWN ] button once, the figure will decrease 1
unit. Press and hold the [ DOWN ] button, the figures will
decrease rapidly.
5.Press [ MODE ] button to confirm setting and enter to next
parameter.
6.Sequence of setting: 12/24Hr  Hour  Minute  Year
 Date format (Month/Date or Date/Month)  Month 
Date  Language  Exit
LANGUAGE
Sequence of setting language:
English (E)German (D)French (F)Italian (I)
EN
IT
DE
FR
ES
7