Operating Instructions; Maintenance; Assembling The Vacuum Kit Ib-2010; Identification And Spare Parts Order - IBEA TURBO 50 Notice D'emploi Et D'entretien

ATTENTION:
1. Always handle fuel with maximum care.
2. Refuel outdoors using a clean funnel to prevent spilling.
Wipe up any spilt petrol.
3. Refuel only after turning the engine off and when engine
is cold. Do not fill beyond 15 mm from top of fuel tank
as fuel expands when hot.
4. When filling tank, keep away from open flames and
sparks and DO NOT smoke!
5. Do not mix oil with gasoline. (See engine manual for
further informations on oil and fuel).

6 - OPERATING INSTRUCTIONS

Working height adjustment (Fig. 5)
1. Place your vacuum cleaner on a level surface.
2. Set the working height like shown in Fig. 5.
You must do this operation with the motor switched OFF.
Operating instructions
1. Check that the high tension wire is on the spark plug.
2. Move the throttle lever to the
3. Press the pump 3 times to enrichen the carburation (Fig.
7).
4. Move the stop switch in operating position. (Fig. 8).
5. Slowly pull the starter handle until the cord is stretched
tight and then pull hard to start the engine (Fig. 9).
ATTENTION:
For starting up with engine already heated it is
not necessary to press the Primer pump.
To sop the engine move the throttle lever to the STOP
position.
Precautions during use (Fig. 10)
1. Keep people and animals away from the cut-
ting area.
2. Operate only with grassbag in position.
3. Keep hands and feet away from the chute door
and the rotor under the deck.
4. Always wear headset to protect your ears from
excessive noise during operation.
ATTENTION:
Before unzipping the bag, make sure the engine
is off and the rotor has stopped.
position (Fig. 6).
12

7 - MAINTENANCE

ATTENTION:
Make sure the engine is off and the plug discon-
nected.
Cleaning the air filter (Fig. 11)
Clean the air filter every 25 hours. Replace it every season
(see engine manual for further information).
Throttle cable adjustement (Fig. 12)
Loosen casing clamp screw (1).
Move governor control lever (2) in direction of arrow as far
as possible.
Move throttle control to position
Tighten casing clamp screw..

8 - ASSEMBLING THE VACUUM KIT IB-2010

Assembling the Kit (Fig. 13)
1. Remove the additional plug.
2. Insert the adapter into the mowerdeck.
3. Insert the hose into the adapter.
4. Insert the vacuum spout into the hose.
5. Apply the tie strap to the lower part of mowerdeck.
Leave the unit on a level surface and shift the throttle lever to
the position (Fig. 14).

9 - IDENTIFICATION AND SPARE PARTS ORDER

Your vacuum cleaner has 2 identification numbers: the
model number and the serial number.
Numbers identifying your machine are indicated on a decal
applied on the chassis.
In any correspondence concerning the mower, quote the
model and serial numbers to assure correct information and
obtain replacement parts efficiently.