Unpacking And Inspection - Beha-Amprobe ACD-14-PRO Manuel De L'utilisateur

page de 242

/ 242
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

• Remove test leads from the meter before opening the Meter case or

battery cover.

• Remove the jaw from all conductors before opening the Meter case or

battery cover.

• Never operate the meter with the battery cover removed or the case

open.

• Never remove the battery cover or open the case of the meter without

first removing the test leads or the jaws from a live conductor.

• Use caution when working with voltages above 30 V AC rms, 42 V AC

peak, or 60 V DC. These voltages pose a shock hazard.

• Do not attempt to measure any voltage that might exceed the

maximum range of the meter.

• Use the proper terminals, function, and range for your measurements.

• Do not operate the meter around explosive gas, vapor, or dust.

• When using probes, never touch the probe beyond the barrier.

• When making electrical connections, connect the common test lead

before connecting the live test lead; when disconnecting, disconnect

the live test lead before disconnecting the common test lead.

• Disconnect circuit power and discharge all capacitors before testing

resistance, continuity, capacitance or diodes

• Use only 1.5V AAA batteries, properly installed in the meter case, to

power the meter.

• To avoid false readings that can lead to electrical shock and injury,

replace the battery as soon as the low battery indicator (

Check meter operation on a known source before and after use.

• When servicing, use only specified replacement parts.

• Adhere to local and national safety codes. Individual protective

equipment must be used to prevent shock and arc blast injury where

hazardous live conductors are exposed.

• Only use the test lead provided with the meter or UL Listed Probe

Assembly rated CAT III 600V or better.