babymoov milky now Notice D'utilisation page 12

Masquer les pouces Voir aussi pour milky now:
Table des Matières

Publicité

1
FUNCTION
x 1
KEEPING WATER HOT FUNCTION
This function starts automatically once the required temperature is reached. It will remain active for 6 hours unless any other
button is pressed. After 6 hours, the appliance turns itself off and the water drops down to room temperature.
x 2
12
• CHOOSING THE HEATING TEMPERATURE AND KEEPING THE WATER HOT
1. Press the MODE
to choose the
2. Choose the required temperature by pressing the
buttons. The required temperature must be between 22 °C
and 85 °C.
To set your temperature, press the
Once you have selected your temperature, you will hear a beep.
Once the water reaches the required temperature, there is
another beep.
3. Your water is now hot. Press the
the water:
- Press once: 60ml of water is dispensed.
- Press and hold = water dispenses continuously.
Caution: the water pouring out of the baby bottle water
heater may be hot, take care not to scald yourself.
2
FUNCTION
1. Press the MODE
the
function.
MILKY NOW • Instructions for use
button once
function.
/
button to dispense
• BOILING YOUR WATER TO 100 °C
button twice to choose
2. When you have selected the function and the display is
flashing, choose the temperature you wish to reach after
boiling (between 22 °C and 85 °C) by pressing
the
/
Once you have selected your temperature, you will hear a beep.
The water continues to heat up until it reaches boiling point,
then stops. You will hear a second beep to let you know that
the water has reached 100 °C.
The water will then cool down via the fan until it reaches the
pre-set temperature. There will be a final beep to alert you.
/
buttons.
buttons.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

A002301

Table des Matières