babymoov Bébédélice Notice D'utilisation page 10

Bébédélice
EN
- Removing the blades. WARNING: do not forget parts 1,2 and
3 when reassembling the blades in order to avoid any risk
of overheating (see diagram below).
1
2
3
G Descaling the heating tank:
After a certain amount of use, mineral scale may form on
the heating element and damage the Bébédélice. You
should descale the cooking tank regularly by pouring a
mixture of 100ml hot water and 100ml white vinegar on the
heating element.
Leave to soak for at least one or two hours (or more if
necessary) without plugging the appliance in.
Empty it and rinse the heating element with a little water
and a cloth. Do not immerse the Bébédélice in water. Leave
it to dry.
Waste Electrical and Electronic Equipment should be disposed
of by selective collection. Do not throw electrical and electronic
equipment away with un-sorted household waste, but dispose
of it at a selective collection point.
Bébédélice steaming tips
• For steaming soft fruits & vegetables e.g. peaches,
zucchini, spinach - use approx 100ml of water
• For steaming hard fruits or fish use approx 200mls of water
• For steaming hard vegetables or meats e.g. carrot,
pumpkin, chicken, beef – use approx 300mls of water
It is better to add a little extra water rather than not enough!
Steaming, defrosting or bottle sterilising turn control knob
to:
Bottle warming turn control knob to :
Don't forget you can use the liquid captured in the green
tray to help blend foods to a smoother consistency. This also
uses all the wonderful juices and nutrients from the food!
SPECIFICITY PER COUNTRY
UNITED KINGDOM
WARNING: this appliance must be earthed.
IMPORTANT. The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the terminals
in your plug, proceed as follows :
1. Connect Green & Yellow wire to terminal marked E or
or coloured Green or Green & Yellow.
2. Connect Brown wire to terminal marked L or coloured Red.
3. Connect Blue wire to terminal marked N or coloured Black.
If a 13A plug (B.S. 1363) is used it must be fitted with a 3 Amp
fuse. A 5 Amp plug must be protected by a 5 Amp fuse
either in the plug or adaptor or at the distribution board.
If in doubt - consult a qualified electrician.
10
,