Seko PoolOne CS Manuel D'installation page 7

PoolOne Peristaltic Pump | Models: CS · RG · pH · ORP
5.4 PoolOne pH
Constant dosing with pH control meter built in, the pump has galvanised electrical insulation and measure
insulation.
Switch position:
a. MOM: Priming position. The pump is running.
b. ON: Normal position. The unit measures the pH and doses.
c. OFF: Stand by position. The pump is stopped.
Setup
a.
Set the switch to OFF position.
b.
Keep pressed
c.
pH setup menu:
1.
Adjust the dosage method for pH: Acid or Alka
2.
Temperature (fixed value): 25°C
Set Point adjustment
a. Set the switch to ON position.
b. Keep pressed
c. After 3 seconds from releasing the
It is possible to set a value between 3.2 and 8.2 pH, with an increase of 0.1 pH.
When the real measure is lower than 3.2 pH or higher than 8.2 pH, the measure displayed flashes.
Set the switch to ON position then follow the steps below:
H O
2
5 s
Set pH calibration
Note: If you have selected the EasyCal function, the calibration will be made only in 1 point using the 7 pH buffer solution.
During calibration procedure, the hold (setup) LED will turn red.
0000138968
for 3 seconds to enter the SETUP menu.
until the Setpoint value starts flashing, then press again
key, the unit saves the value and displays mem.
1
5
C7ph
9
rev. 1.0
2
6
60 s
10
Save and exit
EN
to increase the value.
3
7 pH
7
C100
11
4
8
5