Setup And Operation; Wiring Diagram; Switch Position - Seko PoolOne CS Manuel D'installation

PoolOne Peristaltic Pump | Models: CS · RG · pH · ORP
5

SETUP AND OPERATION

5.1 PoolONE CS
PoolONE CS: constant dosing pump without flowrate regulation
5.2 PoolONE RG Analogic Pump
PoolONE RG: constant dosing pump with flowrate regulation by trimmer
Remove the plastic cover (1) and adjust flowrate by trimmer (2).
Min flowrate is 35% of the maximum value.
5.3 PoolOne RG-DIGITAL Pump

Wiring diagram:

1. Switch with three positions: ON-OFF-MOM
2. Power Supply cord cable
3. Circulation pump 220-240 VAC input
4. Free
PoolONE RG-Digit: constant dosing pump with flowrate regulation by keyboard
Min flowrate is 10% of the maximum value.

Switch position:

a. MOM: Priming position. The pump runs for 3 minutes at max speed; pressing again the MOM switch
stops the pump.
b. ON: Normal position. The unit doses.
Pump starts dosing at the set speed when an external trigger is detected and stops dosing when the
external trigger is undetected.
For setting the pump speed, press
c. OFF: Stand by position. The pump is stopped.
0000138968
1
or to adjust the speed from 10 to max. 100%.
rev. 1.0 EN
2
4
3
1
2
4