Rinsing Cycle; Replacing The Light Bulb; Cleaning The Condenser - Polar DB331 Mode D'emploi

UK
4. Introduce the auger, engaging head (C) with
shaft (D). If necessary, rotate the auger to
engage it.
5. Setting the bowl back in place: Slightly
raise head (C) of the auger so that it meets the
seat (E) provided in the bowl.
6. Press the bowl downward until it get engaged
as shown.
10
DB331_DB332_DB843_ML_A5_v2_20210705.indb 10 DB331_DB332_DB843_ML_A5_v2_20210705.indb 10
7. To refit the tap assembly, follow below
instructions:
• Using the vaseline provided, adequately
lubricate the cap (Y), and refit the
components.
• Introduce the pin (F) while keeping the
tap lever steady.
Always ensure to lubricate the
cap. Otherwise, product leakage
from the tap may occur.

Rinsing cycle

Caution: After re-assembly and
before re-starting the appliance
for serving, make sure to carry
out the rinsing cycle.
1. Fill the bowl with clean water.
2. Run the cleaning mode. For details, please
see Section "To simply clean the desired
bowl".
3. Turn off the appliance. Then empty the bowl.

Replacing the light bulb

Light bulb replacement should be carried out only
by professional technician. For details, please refer
to our service manual available online.

Cleaning the condenser

Periodically cleaning the condenser can extend the
life of the appliance.
POLAR recommend that a POLAR agent or qualified
technician should clean the condenser.
2021/7/5 09:43 2021/7/5 09:43