Ordering Spare Parts And Accessories; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Transport - EINHELL TC-TS 2031 U Instructions D'origine

Never hold the part which is to be cut off.
•
Push the cross stop (14) forward until the
workpiece is cut all the way through.
•
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.

9. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
10. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
10.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
10.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_TC_TS_2031_U_SPK9-1.indb 31 Anl_TC_TS_2031_U_SPK9-1.indb 31
GB

10.3 Ordering spare parts and accessories

Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu

10.4 Transport

Only ever transport the machine by lifting it by the
saw table. Never use the safety devices such as
the saw blade guard and stop rails for handling or
transporting purposes.
10.5 Additional notes on maintenance
Check the following each time before using
•
The machine's emergency stop function (11)
•
The braking time after switching off (<10
seconds)
If the emergency stop function is defective or the
braking time exceeds 10 seconds, do not use
the machine any more and contact the customer
services team.
Always ensure that you place the machine on a
fi rm surface during transport, assembly, disas-
sembly, disabling and scrapping, to make sure
that it cannot topple over, fall over or move in an
uncontrolled manner.
- 31 -
!
02.12.2019 07:41:43 02.12.2019 07:41:43