Heating cable adhesive
(not included in all packs, can be ordered separately)
Properties
The heating cable adhesive is a rod-shaped hot melt adhesive for hot adhesive
guns (Ø 12 mm), which is extremely adhesive. The adhesive has a processing
time of 30 seconds, depending on the size, temperature and thermal
conductivity of the material to be glued. The correct strength is achieved when
the adhesive or glued joint has cooled to room temperature.
Processing temperature: +200° to +220°C.
Temperature resistance: +70°C.
Storage: at room temperature.
Range of application
The heating cable adhesive can be used for fixing heating cables on rough-
casting, plaster, priming compound and tiles. A metal mesh must be secured
with heating cable adhesive to dimensionally stable wooden surfaces and
plastic mats, after which T2Blue is applied to the metal mesh.
Instructions for use
The surface must be dry and clean. Gluing should be carried out at room
temperature, and good ventilation must be provided. All other instructions
apply to the use of the appropriate glue gun.
The components of the product are classified, according to the law,
as not hazardous to health or inflammable.
N.B. Risk of burns from molten glue and hot tool.
Installation stages: Determination of heated surface
C
DEUTSCH
Allgemeines
Pentair Thermal Management bietet eine 12-Jahre Total Care-
Garantie für dieses Produkt. Bitte prüfen Sie das Total-Care-
Garantie-Zertifikat und Registrierungsformular (einschließlich
In-Betriebnahmeprotokoll, herunterladbar von der Internetseite
www.raychemfloorheating.com) für weitere Informationen. Bitte
lesen Sie die komplette Anleitung sorgfältig durch. Beachten Sie die örtlichen
Begebenheiten sowie länderspezifischen Standards und Richtlinien. Der
Inbetriebnahme-Bericht muss von einem qualifizierten Elektriker ausgefüllt
werden. Dieser sollte gemäß den Elektrovorschriften und den Total Care
Garantie Bestimmungen bei dem Hauseigentümer aufbewahrt werden.
8