Trilux LMS HFSB/X RMC Mode D'emploi page 8

Teach-IN
Twilight setting via the save button/teach mode.
This button should be pressed upon desired light conditions below
which the sensor should respond in the future to movement.
The momentary twilight value is saved.
Teach-ALL
send
Individual brightness value measurement for each master luminaire
all
is implemented by successive pressing of the "Teach" + "send last"
buttons.
Test mode
The test mode is for checking functionality and the detection range.
install
The luminaire switches on for 8 seconds with movement independent of
brightness. Test mode has priority over all other settings.
Test mode is automatically exited after 10 minutes without a button
being pressed, or with renewed pressing of the "install" button.
Continuous light ON/OFF
The button toggles between activation of 4-hour continuous light
4 h
(feedback LED flashes x4) and activation of normal mode (feedback
on/off
LED flashes x2).
Basic brightness (factory setting: day and night)
Basic brightness 10 minutes
10
Follow-up light after main light.
min
Basic brightness throughout the night
Basic brightness day and night
Basic brightness level/main light level
LOW/HIGH
(Factory setting: 0% basic light, 100% main light)
LEVEL
The set values enable illumination with 0-50 % (basic light) and
set %
50-100 % (main light).
level
The light is switched to the selected settings for the set time (see delay
time) only with movement in the detection range.
(upper value = basic light level, lower value = main light level).
0 %
50 % Press to select the required level for basic brightness. To set the main
light, press "set level" and the button with the desired value.
The last implemented setting always applies.
8