Operating Modes - Lufft E200IR Manuel D'utilisation

6.1 Operating modes

TH IR DP CFG
TH
shown in the upper display and the humidity in the lower display.
The unit of temperature (°C, °F) is set in configuration area Unit 1 in
this mode. °C is set at the factory. The units for humidity (% r.H., g/m
dp °C, dp °F) are set in configuration area Unit 2. % r.h. is set at the
factory.
B - 09
TH: The instrument can be used
as a thermohygrometer when you
select the TH mode.
In this mode the temperature is
Operating manual – English
An offset correction of temperature and humidity values can be made
in the configuration areas CAL 1 and CAL 2.
TH IR DP
IR
has been designed exclusively for interior pyrometric surface
3 , temperature measurements.
The surface temperature is indicated in the upper display in this mode.
The corresponding HOLD, MAX, MIN or AVG value is indicated in the
lower display if one of these functions was selected in the upper menu.
IR: The instrument can be used as
a pyrometer when you select the
IR mode. In this mode you can mea-
CFG
sure the temperature of surfaces
without contact. The instrument