Menabo paddy smart pad Manuel D'utilisation page 10

In case the driver steps away from the vehicle and the mobile phone has been left in the car, along with an
unattended child in the car seat, after a distance of approximately 10-15 meters the device will switch to the
"alarm mode", activating a sound alarm and the LED shall flash continuously.
The device shall remain in such mode until the alarm is deactivated and the child removed from the seat. If
the alarm is not deactivated by pressing the button on the device or by removing the child from the car seat
within 30 seconds, the APP will send a message to all the predefined associated users such as:
"(NAME OF THE CHILD) HAS BEEN ABANDONED AT GPS 22.3213N 113.9433E)".
The associated users can access the map on the phone and view the exact location where the child was left
unattended. Then they can contact the other users and proceed to rescue the unattended child.
If the driver presses the PADDY ALERT button for at least one second, the LED will flash from 1 to 4 times and
will also show the battery charge. If it only flashes once, then the battery needs to be replaced.
USING THE DEVICE WITHOUT THE APP
PADDY ALERT can be used with PADDY Smart Pad as an alarm that shall go off when the user moves away
from the vehicle and the child has been left unattended in the car seat. The alarm will be both audio and
visual and shall remain active until the child is removed from the PADDY Smart Pad.
Note : The device must be paired with the PADDY Smart Pad as follows :
Press the button for 1 second to turn on the device: a beep will confirm the device is ON.
Press the button again for 6 seconds to turn on the pairing mode (only the first time). Press the center of the
PADDY Smart Pad until a beep sound is heard: the device is now connected to the Smart Pad. The LED flashes
every 8/10 seconds if the battery of the Smart Pad is charged; otherwise the LED will flash continuously.
• If the connection with one or more Pads is lost, the device will go into the alarm mode.
• To stop the alarm mode, press the button for 1 second.
• To cancel the present operating connection press down the button for 6 seconds with the power ON
• To erase all paired PADDY Smart Pad connections, hold down the button for 15 seconds: a confirmation
beep will be heard.
• If PADDY ALERT is connected the first time with the APP it will act as a secondary alarm, otherwise it will
function as primary alarm.
10