Suction Head Assembly; Pool Preparation; Operation - Kokido Telsa EV30 Manuel D'utilisation

Suction head assembly

Insert the suction head directly into the suction mouth of the pool vacuum until the side
tabs of the transparent canister clip in the side holes of the suction head.
NOTE: To replace the brushes on the suction head, lift one end and pull the brush out to
make space for a new one.
WARNING! For vinyl liner and fibreglass pools, it is recommended to keep the brushes
on the suction head to avoid damaging the pool.

Pool Preparation

- If there are stones, roots or metal corrosion in contact with the underside of the
liner, discard them prior to using the pool vacuum. If necessary, seek assistance
from a qualified professional.
If the liner is brittle, damaged or wrinkled, contact a qualified professional to
-
perform the necessary repairs or perform a liner replacement prior to using the
pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing
the pool vacuum into the water.

OPERATION

WARNING!
Make sure the pool vacuum is off

Do not use the pool vacuum if any damage is detected.

14