Operation And Function - Nordcap W32 Mode D'emploi

Operation and function W38.
Electronic control
The electronic control ensures that the set
temperatures are maintained in the cabinet
compartments. This is accomplished by
complex control of the refrigerating system,
the heating element, and the fan. Following
any power failure, the temperature setting is
reverted to factory defaults:
Left compartment: 7°C
Right compartment: 12°C
The electronic controls have the following
functions:
● Temperature setting
● Temperature display
● Automatic defrosting
● High and low temperature alarm
● Light on/off
● Cabinet on/off (push and hold for 3 secs)
Temperature display
The display shows the actual temperature
in the compartments. The temperature
display has a built-in filter that simulates the
actual temperature in the bottles. The dis-
played temperature is therefore not affected
by transient fluctuations in air temperature.
Temperature setting
The temperature is set using the two but-
tons on the control panel. When pushing
a temperature button, the display changes
from actual temperature to set value. After
this, it is possible to change the set value.
Up = temperature up
Down = temperature down
The temperature in both compartments is
adjustable from 5-18 degree Celcius.
The new set value is automatically stored
after 5 seconds of inactivity and the display
switches back and shows the actual tem-
perature again.
Temperature alarm
If the temperature has deviated 3°C from
the chosen set value for at least 1 hour,
the display flashes and Lo / actual respec-
tively Hi / actual temperature are alternately
shown.
It is recommended that wine be served at a
temperature which is a couple of degrees
lower than the desired drinking temperature
as the wine will be warmed slightly when it
is poured into the glass.
9
9
GB