Bosch GardenPump18V-2000 Notice Originale page 13

Place the hose guide on the rim of the water tank and ensure
that the pump is in the correct position. If necessary adjust
accordingly.
Attach a garden hose with a standard hose coupling to the
anti-siphon connector (5).
Note: Do not use a hose coupling with auto stop as this may
reduce the flow.
Using closed Rainwater Tanks
The pump can also be used with closed water tanks. De-
pending on the version, use the access points for cable and
hose at the top of the tank. In some cases the openings must
be cut out. Make sure there are no sharp edges/burrs.
Inserting the Battery (see figure L)
To open the control unit , pivot the locking handle upward
and pull the control unit cover down. Insert the battery from
above into the control unit until it engages.
Close the cover and pivot the locking handle downward. The
pump can only be started if the control unit is locked with the
locking handle.
Finished assembly (see figure M)
Make sure that the water tank is always closed with a lid or
the like, to ensure that no children or animals can fall into it.
Operation
If no more water can be pumped, a dry-run protection fea-
ture switches off the pump automatically.
Switching On and Off (see figure N)
To switch on the pump, press the On/Off switch . The bat-
tery charge indicator lights up.
The battery charge-control indicator indicates the charge
condition of the battery:
LED
Continuous light, green
Continuous light, yellow
Continuous light, red
Troubleshooting – Causes and Corrective Measures
Rainwater Pump
Problem Possible Cause
Warning triangle flash- Battery too hot/cold
ing Red
Warning triangle flash- Dry-running protection has been activated
ing yellow
Bosch Power Tools
LED
Flashing, red
Note: An illuminated warning triangle indicates a malfunc-
tion in the device, see section "Troubleshooting - Causes and
Corrective Measures".
To switch off the pump, press the On/Off switch again.
Timer function (see figure O)
To activate the time function, press the time function button
when the pump is switched on.
After pressing once, the running time is 5 min. With each fur-
ther press, the running time of the pump increases by 5 min,
up to 15 min.
The selected running time is indicated by the corresponding
LED .
After the preset time has elapsed, the pump switches off
automatically.
To switch off the time function, press the time function but-
ton until the indication goes out.
Removing the Battery (see figure P)
To open the control unit , pivot the locking handle upward
and fold the control unit cover down. Press the release but-
ton and pull the battery upwards out of the control unit. Do
not use force to do this.
Close the cover to prevent moisture from entering.
Cleaning the Filter (see figure G)
The pump (11) is equipped with a filter (10) to prevent
damage from contamination. Inspect and clean the filter reg-
ularly.
Pull off the filter downward. Clean the filter under running
water and then attach the filter onto the pump again.
Cleaning the Anti-Siphon Connector (see
Charge Condition
figure I)
> 50 %
If the anti-siphon connector (5) is blocked, remove the cap
50 % − 20 %
(14) and the ball (15). Clean the anti-siphon connector (5)
under running water. Replace the ball (15) and fit the cap
< 20 %
(14).
Charge Condition
Discharged, remove
and recharge battery
Corrective Measure
Allow to cool/warm
Switch machine off and reposition pump so that
is fully submerged
F 016 L94 302 | (23.07.2021)
English | 13