Dmx512 Connections - BoomToneDJ Quattro Roll LED Mode D'emploi

(1) Black Out : on /off Switch
(2)Auto : Auto mode(Press "+"or"-" change show 0 to show9)
(3)Sound : Sound active mode
(4)Strobe : strobe switch (Press "+"or"-" change strobe speed)
(5)FADE/JUMP : no function
(6)Sensitity : Enter the voice sensitivity adjustment menu
(7)R/G/B/A/UV/W : led on/off Red/Green/Blue/Red+Green/Green+Blue/White
(8)+ : Increase (strobe speed /show mode/Sound sensitity )
(9)－ : decrease(strobe speed /show mode/Sound sensitity)
(10) Button 0-9 : For show effects selection

8. DMX512 Connections

The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. Connect the fixture together in a "daisy chain" by XLR plug cable from the output
of the fixture to the input of the next fixture. The cable cannot be branched or
split to a "Y" cable. Inadequate or damaged cables, soldered joints or corroded
connectors can easily distort the signal and shut down the system
3. The DMX output and input connectors are pass-through to maintain the DMX
circuit when one of the units' power is disconnected.
18