Battery Replacement - SBS GO LIFE Série Mode D'emploi

Sensor zone
Sensor zone
Battery cover
CR2032 battery
4
Close
Open
Coin
3
Adjust the position of cadence
magnet and sensor so that the
magnet passes close to the
sensor without touching it. The
gap between sensor and magnet
should be between 2-5 mm.
4
Use the screwdriver to adjust the
sensor position carefully.
5
The small caved dot in the sensor
backside should indicates the
right point where the magnet must
be point at when in movement.
6
Try to rotate the crank to check
the cadence sensor: when in
correct position, fi x it using the
nylon cables.
_______________________________

Battery replacement

Speed/cadence sensor contains a
replaceable CR2032 battery placed
under the cover.
Once located the battery, to change
it remove using a coin to open.
Remove cover and battery, wait 30
seconds, insert the new battery and
close again using a coin.
Make sure to properly replace the
protective O-ring inside.