Power Supply And Electrical Connections - DELTACALOR Dryer Plus Electric Notice D'utilisation Et D'installation

Table des Matières

Les langues disponibles

POWER SUPPLY AND ELECTRICAL CONNECTIONS

• In accordance with the rules in force, the power of the heating

appliance must be protected by an RCD of 30 mA and an over-

current protection device, suitable to the characteristics of the

connection line.

• Before using the appliance the first time, check that the volt-

• Before using the appliance the first time, check that the voltage

used corresponds to that specified on the appliance.

age used corresponds to that specified on the appliance (sin-

gle-phase power supply 230 V~ ±10% 50 Hz).

• This heating appliance is a class II appliance (double electrical

insulation).

insulation). For this type of equipment, no earth connection is

• Earth connection is prohibited.

required.

• Connection of the three wires must take place in an electri-

• For units fitted with a plug, the connection must only be formed

cal junction box compliant with current regulations.

using a suitable electrical socket.

• In terms of French regulations, do not fit a plug to the cable

• In the version with a power supply cable without a plug, the

for connecting it to an electrical socket.

three-wire connection must be done in an electrical connection

• The pilot wire must be disconnected if not in use.

box that conforms to the current norms.

• In the version without a plug, in accordance with French regu-

Single-phase power supply 230 V~ ±10% 50 Hz.

lations, do not fit a plug to the cable for connecting it to an

• Blue/gray wire: Neutral

electrical socket.

• Brown wire: Live

• The pilot wire must be disconnected if not in use.

• Black wire: Pilot Wire

• Blue/gray wire: Neutral

• Brown wire: Live

• Black wire: Pilot Wire

[ 36 - EN ]

Table des Matières