Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1.
RF receiver headphones
2.
RED LED HEADSET: headphone on/off
3.
On/Off Switch
4.
Headphone Charging Contacts
5.
GREEN HEADSET LED: signal indicator
6.
AUTO TUNE button
7.
Volume Control Wheel
8.
RF Transmitting Base
9.
GREEN LED BASE: Charging indicator
10. RED LED BASE: Signal presence indicator.
11. Base charging Contacts
12. Audio cable connector 3.5 mm jack
13. AC Power Supply Connector
14. Channel Selector (CHANNELS 1 2 3)
15. 1.2 V Ni-MH rechargeable batteries (AAA size)
16. AC adaptor
17. 3.5 mm/RCA jack adaptor
18. 3.5 mm audio cable jack
• Turn on the headphone power by removing the 2 insulating tabs that stick out from the right of the stand. (FIG.2)
• Make sure the headphones are switched off, and check that switch 3 is turned to OFF.
• Connect the AC adaptor cable to connector 13 (DC IN input) located on the rear of the base.
• Connect the AC adaptor to the mains supply.
• The RED 10 LED on the base will light up.
• Select one of the 3 available channels.
• Place the headphones on the base slots (the headphones must be turned off) and make sure the green CHARGE 9
LED is on to indicate correct contact has been made between the headphones and charging contacts 11 .
• Leave the headphones to charge for 12 hours (at least for the fi rst use).
CONNECTING THE AUDIO SOURCE (after charging the HEADPHONES)
Before making the connections, ensure that the Transmitting Base is switched off.
• Locate the headphone audio output (3.5 mm stereo jack plug) on the TV or the audio device you want to connect to.
This is usually indicated by the symbol
WARNING: should not be confused by using another type of JACK that some TVs have as a PC audio input.
• Connect one end of the audio cable jack to base 12 and the other end to the headphone audio output which is on the TV.
If the device does not have an output JACK for headphones, read the chapter: "ALTERNATIVE AUDIO CONNECTION".
• Turn on the base and the connected audio device.
• Remove the headphones from the recharging base.
• Make sure that the RED 10 "SIGNAL" indicator lights up on the base, which indicates the presence of an audio
signal being input to the transmitter.
If this is not the case, the volume of the player (TV) should be increased.
• Generally, when the jack is plugged in, the connected device (TV) no longer plays the sound through its own speakers.
CAUTION: some TVs have separate volume controls for SPEAKERS and HEADPHONES; use the latter one.
• Whilst staying near the base, turn the headphones on using the POWER 2 button, and check that the red led lights
up, red light comes on, then wait a few moments.
• Check that the GREEN 5 light on the left earpiece of the headphones lights up. If it does not, press the 6 AUTO-
TUNE button for a second.
• Put the headphones on, and turn the wheel 7 to adjust the volume and achieve proper sound reproductions.
If the headphones fail to reproduce the audio, or if there is any interference with the audio, please consult the
"TROUBLESHOOTING" section.
14
Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 14
Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 14

Product Overview

Installation
.
03/08/18 14:35
03/08/18 14:35

Publicité

Table des Matières
loading

Table des Matières