SCHOCK STIB64BKM Notice D'utilisation page 16

The control panel displays [ L ] :
• Refer to the chapter control panel locking page.
One or all cooking zone cut-off :
• The safety system functioned.
• You forgot to cut-off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of power level and breaking Automatic
overheating
Continuous ventilation after cutting off the hob :
• This is not a failure, the fan continuous to protect the electronic device.
• The fan cooling stops automatically.
The automatic cooking system doesn't start-up :
• The cooking zone is still hot [ H ].
• The highest power level is set [ 9 ].
The control panel displays [ U ] :
• Refer to the chapter "Keep warm".
The control panel displays [ II ]:
• Refer to the chapter "Pause ".
The control panel displays [ ∏ ]:
• Refer to the chapter "Bridge".
When the symbol [ E 4 ] appears :
• The table must be reconfigured. Please implement the following steps :
I) Important : before you start, make sure there is no more pot on the hob
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit
breaker off
III) Reconnect the table to the grid
IV) Procedure :
* take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don't use the [
V) First step : cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively and
quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn contrary
clockwise, as described on the picture
(from a to d).
A double "beep" means an error occured. If so, start again from item 1).
4) Remove the fingers of the keys. In the back left display a "C" and a"0" appear
flashing alternately. Meanwhile a standing "0" is displayed in the font left zone.
5) Remove your fingers from the touch control, then push again on touch 1 during few
seconds, until blinking [ E ] symbols appear.
6) Wait until [ E ] symbols stop blinking.
7) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
] touch
16
c
d
b
a