Busch+Müller IXON Eyro Notice D'utilisation page 12

! Insert the headlight into the headlight holder from the left in the direction of travel and firmly push it
into place until it audibly engages. Be sure to check that it is securely seated. To remove the headlight,
press the release button on the holder (located to the right of the headlight in the direction of travel),
while firmly holding the headlight and pull it off to the left. We exclude liability for any damage caused by
falling, e.g. because the headlight was not held tight while it was removed. If the structural situation on
the bicycle only allows the locking button to point away from the cyclist rather than towards him, use a
screwdriver to loosen the holder adapter on the top of the holder, turn it by 180° and then affix it again.
The headlight can be swivelled vertically and, horizontally by a few degrees. In both cases, the locking
screw of the holder must be loosened.
Vertically: The headlight's tilting angle is determined by the position of the handlebar attachment.
Horizontally: The headlight can be swivelled infinitely (to a limited extent) to the left or right on the
rubber ring.
22
CORE
4
4
6.2.2. Mounting instructions for Eyro
Use the enclosed stainless steel holder from Busch + Müller to securely fasten the headlight on
the bike's steering head. Carefully tighten the screws on the headlight in a way to prevent the
headlight from moving in the holder all by itself.
The headlight 1 can be removed from the holder
locking mechanism upwards. It can be additionally locked by turning the circular locking
3
mechanism .
3
FYRE EYRO
1
3
4
2
2 and reinserted after pushing the
23