Busch+Müller IXON Eyro Notice D'utilisation page 10

! Never cover or conceal bicycle lights. Always make sure the bicycle lights are correctly adjusted. In
general, the prescribed mounting height ranges between about 16" to 48". For details consult the High-
way Code or DMV Handbook or inquire with a local bicycle specialist retailer. The prescribed mounting
height ranges between 40 und 120 mm. You will find more details in the Road Traffic Licensing
Regulations. If necessary, contact a local bicycle specialist retailer. Make sure your lights are positioned
and adjusted in a way to ensure they do not blind oncoming traffic.
5. Package content
IXON Core / IXON Fyre:
Headlight | USB mains adapter | USB cable to micro-USB | handlebar bracket | instruction manual
LUMOTEC Fyre
Headlight | USB cable to micro USB | stainless steel bracket | instruction manual
6.1. General assembly notes
No mounting underneath the handlebar: If the headlight is suspended underneath the handlebar, the
light field is reversed and oncoming traffic blinded which is a violation of traffic regulations. Also, we do
we assume any liability for possible splash water damage likely to occur when the headlight is mounted
underneath the handlebar.
WARNING Avoid falls, accidents and serious injuries. Use only the pre-installed Busch + Müller
18
bicycle light mounting brackets. Installing a bicycle light on a bicycle using brackets which are
not suitable or are positioned inappropriately, can lead to the light becoming loose, slipping and
getting caught in the spokes of the wheels.
NOTICE
Never install a bracket on conical fork legs or strut substructure!
Tighten all screws so that the bicycle light cannot move. This is especially important when riding
on uneven surfaces. The light has a sufficiently tight seat when headlight range adjustment is
difficult to adjust its position.
Never adjust the bicycle light while riding! Severe falls and injuries may result. Do
WARNING
not ride the bicycle if the beam issued by your bicycle light is misaligned, or the light is too loose.
Only straighten or fasten the bicycle light when the bicycle is not moving. Dazzling oncoming
traffic can cause accidents. Prior to adjusting the bicycle light, always loosen the bracket screw.
Afterwards, make sure to securely re-tighten the bracket screw again.
Never look into the bicycle light when it is turned on.
WARNING
19