Eaton Metalux RHB Instructions D'installation page 3

4. Loosen the 2 screws on top of the adjustable mounting
plate by 1.5 turns, then slide the adjustable mounting
plate until luminaire hangs level, using water level to
assist if necessary. Retighten the 2 screws. (Figure 8)
Figure 8.
5. Remove the screw on the junction box cover on the
front of the luminaire and remove junction box cover.
(Figure 9)
Figure 9.
Installation Instructions – RHB Base Luminaire
6. Verify that the pendant stem is fully engaged with the
adjustable mounting plate by ensuring that the bottom
of the pendant stem is flush with or protrudes slightly
beyond the bottom of the adjustable mounting plate.
(Figure 10)
Figure 10.
7 . Wire according to NEC code. (Figure 11)
8. Replace junction box cover and reattach cover screw.
Figure 11.
EATON IB519076EN
Black - Live
White - Neutral
Green - Ground
Installation Instructions
3