HAEGER HP-IND.002A Mode D'emploi page 11

Overview of error messages
If an error message appears on the display, follow the instructions in this table.
Error message
The display shows
error message E0.
The display shows
error message E1 or
E2.
The display shows
error message E3 or
E4.
The display shows
error message E5.
The display shows
error message E6.
Instructions for use
Possible cause of the error
There is not cookware
placed on the hotplate or
the cookware is not
suitable for induction
cooking.
Temperature sensor
failure.
The voltage in the power
socket to which the
induction cooktop is
connected is too high or
too low.
Overheating of the
hotplate.
The thermal fuse was
activated, turning off the
induction cooktop due to
overheating.
Solution
Place cookware
suitable for induction
cooking on the
hotplate, see chapter
Types of cookware
suitable for induction
cooking.
Send the induction
cooktop to an
authorized service
centre for repair.
Connect the induction
cooktop to a
corresponding power
socket with is a voltage
of 220-240 V.
Allow the hotplate to
cool down. Then you
can put into operation
again.
Allow the induction
cooktop to cool down
and make sure that the
air inflow or exhaust vent
is not blocked. If the
problem persists, send
the induction cooktop
to an authorized service
centre for repair.
English
9