Switching Off; Malfunctions - FireWare Pandora's Box 025-012-011 Mode D'emploi Utilisateur

Manual
EN
FireWare Pandora
5.

Switching off

Switch the device off with the on/off switch (A) after use. If the Pandora's Box is not switched off,
it will remain stand-by and thus continues to consume power. In order to prevent the battery from
running down while the device is stored, the Pandora's Box needs to be charged using the C-tek
charger. Connect the C-tek charger to the connection panel (F) on the device and connect the
system to the power supply.
6.

Malfunctions

Problem
The device doesn't turn on
Device doesn't play audio
Device fails to play a
specific sound
Device doesn't activate
lights
Interrupted charging
session
16 FireWare Pandora
Cause
The battery is dead, not connected
or broken
Indicator off: battery broken
Indicator red: battery is dead
Indicator orange: the device has
used half its operational time
Indicator green: battery is fully
charged – device is stand-by –
ready-to-use
Device is not switched on.
Battery is dead
Damaged remote control
Battery remote control is dead
Check the battery indicator
Battery is dead
LED defective
The battery could have seriously
grown acid.
Solution
Check the battery indicator on
the C-tek charger and follow the
abovementioned steps.
When hearing a continuous
clicking sound upon turning the
switch: please contact FireWare
Please contact FireWare
Immediately charge the device.
Charge the device.
Charge the device. If ineffective,
please contact FireWare
Turn the device on using the on/
off switch
Please contact FireWare
When you hear a continuous
clicking sound when turning the
switch: please contact FireWare
Try activating a different sound /
a different function
Replace the remote's battery
Act according to abovementioned
schedule
Please contact FireWare
Please contact FireWare
Please contact FireWare
www.FireWare.nl