Whirlpool W11508871A Instructions D'installation page 13

2. Remove the cap from the gas pressure regulator using a
flat-blade screwdriver.
NOTE: Be sure sealing washer remains in the same position.
3. To convert to Propane gas, unscrew the plastic adjustment
screw by hand, turn it over, and screw it in again.
Inlet pressure
to Natural gas
A
B
C
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
To Convert Surface Burners
1. Remove burner grate, burner caps, and burners.
C
A
B
A. Burner cap
B. Burner
C. Center burner
2. Locate the Propane gas orifice spuds for top burners in
the bag containing literature included with the range. Two
Propane gas spuds are stamped "073," two are stamped
"117," and one is stamped "088."
3. Remove Natural gas orifice spuds using a 7 mm (9/32")
combination wrench.
A
A. Cap
Inlet pressure
to Propane gas
180°
4. Install Propane gas orifice spuds using a 7 mm (9/32")
combination wrench.
NOTE: The range cooktop is equipped with 5 burners: 2 burners
are power (front), 2 burners are standard (center and left rear),
and 1 is simmer (right rear).
A
B
A. Standard burner - Propane gas orifice spud number 088
B. Power burner - Propane gas orifice spud number 117
C. Center burner - Propane gas orifice spud number 088
D. Simmer burner - Propane gas orifice spud number 073
E. Power burner - Propane gas orifice spud number 117
5. Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
6. Reinstall burners, burner caps, and burner grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks and oven tray
with flame spreader, and set aside.
2. Remove screw from the oven burner. Lift oven burner and
pull the burner toward you. The orifice spud is behind the
oven burner air shutter.
B
A. Oven burner
B. Air shutter
C. Screw
A
A. Spud
D
C
E
A
C
13