Fusion Tweeter SG-TW10 Instructions D'installation page 4

Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The audio is distorted
• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
Specifications
Max. power (Watts)
RMS power (Watts)
Efficiency (1 W/1 m)
Frequency response
Nominal impedance
Recommended amplifier power
(RMS)
Diaphragm material
Min. mounting depth (clearance)
Mounting diameter (clearance)
Compass-safe distance
Operating temperature range
Storage temperature range
Water and dust rating
4
330 W
60 W
91 dB
3 kHz to 20 kHz
4 ohm
From 25 to 140 W per channel
Aluminum (hard dome)
1
31 mm (1 / in.)
4
51 mm (2 in.)
1
110 cm (3 ft. 7 / in.)
4
From 0 to 50°C (from 32 to 122°F)
From -20 to 70°C (from -4 to
158°F)
IEC 60529 IP65 (protected against
dust and water ingress)
Installation Instructions