Enerwatt EWC61224-563 Guide D'utilisation page 12

LED COMMUNICATION OF ABNORMAL RESULTS
No. LIGHT CONDITION
1 Solid Red Warning! LED
2 Flashing Red Warning! LED
Slow flashing red warning
3 +
Solid corresponding charging mode LED
"CHARGING" and "CHARGED" flashing +
4
Other mode lights "OFF"
5 12V Slow flashing
6 24V Slow flashing
Solid Red Warning!
7
+ CHARGED flashing
Corresponding charging mode
8
LED flashing quickly
9 Only corresponding charging mode LED
Red Warning! LED light flashes
10 2x stop for 3secs,
2x stop for 3 secs...
11 Warning! LED
NOTICE: the following situation indicates that the battery needs to be replaced, even if there are no abnormal LED warnings.
Once the battery is fully charged and the battery level indicator confirms this, you can use the battery to start the vehicle's engine.
If the engine cannot be activated (and the problem isn't caused by the vehicle itself ), this indicates that the battery has declined
storage capacity and needs to be replaced. You can also try the REPAIR Mode for recovery (press REPAIR button).
WARRANTY
1. This product is warranted to the purchaser for a period of two (2) years from the date of purchase,
to be free of defects in material and workmanship.
2. Warranty Performance: During the above two (2) year warranty period, a product with a defect will be replaced with a new one.
The replacement product will be in warranty for the balance of the original two (2) year warranty period.
3. This warranty is void if the product has been damaged by accident, in shipment, unreasonable use, misuse, neglect,
improper service, commercial use, repairs by unauthorized personnel or other causes not arising out of defects in materials
or workmanship.
|
Distribué par Distributed by:
TCED INTL. Inc.
700, chemin du Grand Bernier Nord
Saint-Jean-sur-Richelieu
(Québec) J2W 2H1
FABRIQUÉ EN CHINE - MADE IN CHINA
CAUSE(S)
Reverse Polarity
1. Open circuit
2. Dirty Battery Posts
3. Dead Battery
4. Output Short Circuit
Charging in 6V/12V Mode(s)
for 24V battery
Overheat protection
In 12V REPAIR mode
In 24V REPAIR mode
Overload in SUPPLY Mode
(will automatically shut down
for 30 seconds as protection)
Battery cannot store the electric
charge during the charging process
In desulfation process
Battery cannot be recovered
by the desulfation process or
the battery cannot be recovered
by the repair mode
Battery (voltage is less than 3V),
Repair Mode required
MODEL: EWC61224-563
SOLUTION(S)
Swap the red and black clamps or ring terminals
for the correct battery posts
1. Connect the red and black clamps or ring terminals
to the battery posts
2. Clean the battery posts
3. Replace the battery with a new one immediately
4. Disconnect the red and black output terminals
Please do manually press the Mode button to choose
correct charging mode. CAUTION: If you choose the 24V Mode(s)
for a 6V/12V battery, the 6V/ 12V battery will get damaged.
Current reduces when the temperature in the charger is too high.
After cooling down, the charge will begin.
Disconnect the external device
Replace the battery with a new one immediately
1. Replace with a new battery
2. If the battery cannot be recovered by the desulfation process,
try the REPAIR mode.
Battery or try REPAIR Mode for recovery
Phone/Téléphone: 450 348-8720
Toll free/Sans frais: 1 800-661-3330
USER'S MANUAL
-
-
-
12