How To Use - Panasonic CS-Z7SKEW Comment Utiliser L'appareil

How to use

To optimise energy saving
ECONAVI
To select operation mode
MODE
AUTO - For your convenience
HEAT - To enjoy warm air
COOL - To enjoy cool air
DRY - To dehumidify the environment
To maximise comfort while
SLEEP
sleeping
(CANCEL)
• This operation provides you with a comfortable
environment while sleeping. It will automatically
adjust the sleep pattern temperature during the
activation period.
• The indoor unit indicator will dim when this
operation is activated. This is not applicable if the
indicator brightness has been manually dimmed.
• This operation is incorporated with the activation
timer (0.5, 1, 2, 3, 4, 5, 6, 7, 8 or 9 hours).
• This operation can be set together with single
timer or twin timer. Sleep operation has the
priority over OFF timer.
• This operation can be cancelled by pressing the
respective button when the sleep timer reaches
0.0h.
To switch between
powerful & quiet
Remote control display
(
POWERFUL
QUIET
POWERFUL: To reach temperature quickly
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
• This operation reduces airfl ow noise.
Auto OFF/ON button
AUTO
OFF/ON
8
)
(NORMAL)
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Human activity sensor
Remote control display
OFF/ON OFF/ON
MODE MILD DRY
TEMP TEMP
SLEEP
AIR SWING
FAN SPEED
ON ON SET SET
TIMER TIMER
OFF OFF CANCEL CANCEL
To select fan speed
FAN SPEED
Remote control display
(
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
Sunlight
sensor and
remote control
receiver
Indicator
(White)
POWER
(White)
TIMER
(White)
ECONAVI
(White)
nanoe
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
)