NDS 68.book Seite 8 Mittwoch, 20. September 2006 4:01 16
GB
Each time before starting opera-
tion, the proper function of the
PRCD residual current device must
be checked. Do not use the PRCD
residual current device to switch
the machine on/off. The PRCD
residual current device may not lie
in water. The operation of the
machine may not be started when
the PRCD residual current device is
not operative.
When operating the machine, water must not
be able to penetrate the motor or the electrical
components in any working position. Even
when the PRCD residual current device actu-
ates, there is still danger of an electric shock.
On construction sites, electrical machinery may
only be supplied with power via a construction
site distribution board or a separate isolation
transformer.
When water comes out of the control open-
ing 3, stop working immediately and have the
machine checked by an authorized customer
service agent for Würth power tools.
8
For Your Safety
If the cable is damaged or cut through while
working, do not touch the cable but immedi-
ately pull the mains plug. Never use the
machine with a damaged cable.
Only insert the plug when the machine is
switched off, and unplug after use.
Switch off the machine if it should come to a
stop for any reason. After a break or an inter-
ruption from work, only switch the machine on
after having made sure that the core bit rotates
freely.
Always use the auxiliary handle and hold the
machine with both hands. Be aware of the
machine's reaction torque.
When starting the drilling, do not guide the drill
by hand. The machine can injure you, resulting
in loss of control. Work only with a drill-starter
or the drilling jig 14.
Wear safety goggles and hearing protection.
Wear protective gloves.
Take care with long hair. Only work with
closely fitting clothing.
The machine may not be operated by persons
under the age of 16 years.
Use only original Würth parts and accessories.
For further notes on safety, refer to the enclosed sheet