Assembly; Suggestion For Assembly - JETStream LARGO Instructions De Montage Et Mode D'emploi

2

ASSEMBLY

2.1 Suggestions for assembly
Installing the wall fittings in concrete shuttered pools
• Assembly (see picture 1)
Position the suction wall niche into the concrete shuttered pool in such a way that the read label „oben"
is on top and the plug "2" is at the bottom.
The flange of the LARGO or PUNTO shower piece wall fitting must be set flush with the concrete shuttered pool (see picture 2).
Position the pneumatic switch wall niche into the concrete shuttered pool as per picture 1.
In the case of a liner / concrete pool, the wall niche may project in order to compensate for the cement render or liner insulation
thickness. It is advisable to make provision for protecting tube by placing it in a protective conduit or through adjacent cable /
ventilation ducts. Remove protective covers only before tiling.
• Tile plan (see picture 3) Render and tile to inner edge of wall fittings.
• Steel, aluminium and polyester pools (see pictures 4, 5 and 6)
Position rubber gaskets, screws and clamping frames as shown in picture 4.
Installation Suggestion
1
beton
Shuttering
screw
If required
M 6x35
dimensions in cm
2 flange with threaded bushes
wall duct
Protective sleeve for pneumatic
24
tube Wall thickness 24 -100 cm
Pneumatics
switch housing
Shuttering
24
suction
housing
stopper 2"
Shuttering
5
water level
clamping frame
gasket
screw 6 x 30
clamping frame
countersunk screw M5
gasket
screw M 6
suction housing
dimensions in cm
3
4
clamping
frame
sunk screw M6 x 30
pool wall
protection
tube
suction pipe
stopper 2"
24 max
11
render and tile
to inner edge
max thickness
render and tile
poll wall
Flachkopf-
schraube M5
one rubber
gasket to front
and back of liner
In case of a concrete wall thickness of more
than 24 cm, unscrew the protection pipe and
use the enclosed protection tube
8,6
10,2
Ø 0,7
use clamping frame for
cutting and drilling
22,5°
45°
intake screen
M 5
M 6