Remote Control - Impecca HTDS-5175BT Mode D'emploi

GETTING STARTED
Connecting the Speaker Wire
Speaker cables are always split into two
sides.
both the positive (+) and negative (-) sides
of the speaker cable to the back of the unit.
The positive cable is red, with a black stripe.
Make sure that the positive (+) side of the cable is plugged
into the red terminal: Press the red tab on the terminal, in-
sert the wire at the end of the cable and release the tab.
The negative cable (coming from the same speaker) is
black with a red stripe. In the same fashion, make sure the
negative (-) side is plugged into the black terminal direct-
ly below the red one (hold down the black tab to connect).
WARNING: Make sure that positive and negative speaker
wires never touch each other! Always keep black and red
wires separate!

REMOTE CONTROL

Please remove the battery cover on the rear
of the remote control, insert 2 AAA batteries
(not included) then place the cover back on
the remote. Please see the "Remote Control
Buttons section" for a full listing of each but-
ton and what it does.
For each speaker, you must connect
7
AAA